Refitted Mark II C&C 27 Sailboat with steel cradle and trailer in Charlottetown, Prince Edward Island

The Mark II C&C 27 is a Canadian classic sailboat. Selling the package reluctantly at this low price owing to change in personal health.
Bring clean, non-skid shoes to view.
? Thorough refit xxxx-09 cost thousands of dollars.
? Includes dual axle flatbed trailer, new $6,500 in xxxx with upgraded axles in xxxx.
? Includes C&C 27 winter cover with aluminum frame, new $2,200 in xxxx; not used this winter because boat is stored indoors heated.
? Boat purchased in February xxxx and then extensively refitted on land including indoor heated shop winter and spring xxxx-09.
? Surveys in xxxx and xxxx.
? Boat was in fresh water first 25 years.
In this listing, ?new? means new since we purchased the boat in xxxx.
Deck
? New: Blue Natty dodger with optional hand-grip bar. New in xxxx for $1,900. With optional stainless steel grip bar. Capable of being upgraded to full bimini.
? New: Removed all deck hardware and handrails to refit deck.
? New: All deck holes reamed and potted with epoxy. No delamination found, core in excellent shape.
? New: Deck painted with 3 coats of flattened Brightside and 2 coats of Interdeck.
? New: Windows and seals.
? New: Nicro stainless steel solar powered vent.
? New: Six 1? stainless lifeline stanchions (3 each side) between original 7/8? pushpit and pulpit. Replaced their 6 original deck-mounted stanchion bases with new toe-rail mounted bases and new stainless wire lifelines with midship full gates both sides. Cost was $1,700.
? New: Spinlock 4-line running rigger deck organizers each side.
? New: Spinlock XAS rope clutches.
? New: Replaced wooden backing plates with stainless steel backing plates.
? New: system to manage mast wires where they enter the deck base of mast.
? New: chainplates removed, chainplate deck holes epoxy-potted, rebedded.
? New: Bilge pump hose.
? Removed Whale Gusher-10 Mark 2 bilge pump and restored it with paint and valve kit.
? Edson steering wheel pedestal repainted.
? Exterior teak in excellent shape. Refinished with 8 coats of varnish.
? Hatch covers removed and painted.
? Cockpit teak table refinished.
? Older canvas awning, in excellent condition. Added new aft and side extensions in xxxx to keep sun and light rain out of the cockpit at the dock.
? All four Barient winches disassembled, cleaned, lubricated and refitted.
? Teak handrails refinished and need to be reinstalled.
Cabin
? New: Deckhead painted in cabin and head.
? New: Butane stove available.
? New: Curtains.
? New: Whale Galley hand pumps at galley and head sinks.
? New: Toilet and toilet plumbing, including vent loop.
? New: Two fire extinguishers.
? Teak and holly plywood sole plates removed and refinished with Ultimate Sole.
? Table and teak cabinets removed and refinished, spaces behind cleaned and painted.
? Cushions relatively new and excellent shape.
? Freshwater tank.
Hull
? Topsides gelcoat restored.
? Six-pad steel Marine Cradle Shop steel 6-pad cradle.
? New: Soda-blasted then sanded hull and keel.
? New: Faired hull with West Epoxy 205 and 207 filler after revision most of the throughulls.
? New: Interprotect barrier after drying hull for several months.
? New: Micron CSC bottom paint.
? New: Vinyl cove gold and navy bootstripe.
? New: Vinyl name decals both sides and transom.
? New: throughull sounder transducer installed.
? New: Replaced original throughull fittings.
Engine
? xxxx late-model Atomic 4.
? Compression check in xxxx: 110?117.
? New: Stripped engine down to head, block and transmission (left intact in boat) and then repainted and refurbished, with many new accessories.
? Valve tappet clearances adjusted to specifications.
? New: Cooling passage side plate.
? New: Block vinegar-flushed prior to installing Indigo freshwater cooling system. The boat had been in Ontario for the first 25 years, and then came to PEI.
? New: inboard bronze seawater strainer.
? New: vented loop in seawater coolant outlet line to exhaust.
? New: dripless PSS shaft seal.
? New: Electronic Facet fuel pump.
? New: Zenith carburetor with optional knurled idle adjust.
? New: Choke cable.
? New: Indigo PVC valve to minimize fumes.
? New: Two MMI water pumps with quick change plates to facilitate impeller changes.
? New: Optional long stainless steel lower water pump bolt.
? New: Exhaust system including Moyer exhaust flange with backpressure measurement port, galvanized dry/wet stack, Stainless Moyer waterlift muffler, Vetus exhaust hose and new stainless Vetus transom exhaust tip with backsplash flap.
? Monel steel fuel tank.
? New: 5/16? A-1 fuel lines.
? New: Racor fuel/water separator at the fuel tank outlet.
? New: Fuel polishing filter between fuel pump and carburetor.
? New: fuel gauge (not working yet).
? New: Ignition panel, with new tachometer, water temperature and voltmeter gauges, and new blower and panel light switches.
? New: 55-amp alternator.
? New: second ignition switch in cabin to facilitate maintenance.
? New: Engine temperature and oil pressure alarms.
? New: Seawater coolant flow alarm (not fully installed yet).
? New: Oil sump kit to ease oil changing.
? New: Spark plug cables.
? New: Pertronix electronic ignition and Flamethrower coil.
? New: distributor flyweights.
? New: knobbed shifter extension.
? Manifold removed, professionally cleaned and faced, painted and reinstalled.
? Starter motor professionally checked and refitted.
? Moyer and other manuals.
Rigging
? New: Forespar whisker pole. $500 new.
? New: Main halyard, mainsheet, mainsail reefing line and boom turning blocks, boom vang line and block, mainsail downhaul, and furling line.
? New: 4-line Spinlock deck organizers and triple Spinlock XAS rope clutches each side.
? New: Several old blocks replaced with Harken Carbo blocks.
? New: Mainsheet fiddle block (Harken).
? New: Harken furling line blocks and fairleads kit.
? New: Stainless steel plates to bolt onto the mast base to manage the blocks.
? New: Stainless steel starboard sidestay plate on the mast. The rivets in both plates were upgraded to ¼? stainless steel, and anticorrosion gaskets were placed between the plates and mast.
? New: Forward and after stainless wire side stays.
? New: Kit to install on boom to bungee mainsail when it is down.
? New: Fittings for flag halyards both spreaders and adjacent stays.
? New: Wire jib pennant between halyard and upper furling swivel.
? Revised: removed the Ultra Furl furling system and returned the drum and swivel to the Canadian manufacturer for refit fall of xxxx. Also replaced some of the extrusions. The furling system had been functioning well during summer xxxx prior to this preventive refit.
? Older spinnaker halyard.
? Coach-head traveler removed, bolt holes epoxy potted, stainless backing plates at reinstall.
Sails
? Sobstad mainsail.
? Michele Stevens furling foresail.
? Both made for the boat by previous owner about 9-10 years ago.
? New Stevens 100% foresail xxxx.
Navigation
? New: Mast truck anchor light.
? New: Masthead steaming/foredeck light below the spreaders.
? New: Mast electrical wiring, marine-grade silvered wiring supported inside the mast by cable tie springs spaced along the wires.
? New: Sidelights on the bow and sternlight on the transom.
? New: Plastimo Contest 101 dual-view bulkhead compass.
? New: Navman sounder.
? New: Northstar 550i pedestal-mounted GPS chartplotter.
? New: C-Map card covering East coast and Great Lakes.
? New: Software, user C-Map blank memory card and specialized C-Map card reader allowing passage planning on home computer.
? Uniden Solara VHF DSC radio with MMSI number.
? Speed log, countdown timer and sea thermometer.
? Older Autohelm STxxxx self-steering system was functioning for previous owner. The drive unit on the steering wheel was binding, so I removed it to clean the belt.
Electrical
? New: Digital sound system with dual inside/outside speakers and dual zone controls, has iPod docking bay, and uses any USB input.
? New: Wiring almost completely revised.
? New: Removed all the original AC wiring and shore power components and replaced with new marine cable, shore power and stern inlet, and two new GFI cabin outlets.
? New: Removed all engine DC wiring and replaced with silvered marine wiring, bus bars and other enhancements.
? New: Removed all the original cabin and mast DC wiring except some wiring running through cabin deckhead; replaced with new silvered marine wire.
? New: Guest Charge Pro dual bank 20 amp shore power battery charger.
? New: AC Blue Sea breaker panel with dual inlet double throw breakers.
? New: DC Blue Sea digital breaker panel.
? New: AC voltage gauge.
? New: Ignition panel, with new tachometer, water temperature and voltmeter gauges, and new blower and panel light switches.
? New: 55-amp alternator. Modernized the charging system and shortened the alternator output run from original C&C design.
? New: Blue Sea ACR automatic charging relay and manual combiner switch simplifies charging and battery switching.
? New: Two Group 27 12 volt marine batteries, one dedicated to engine start, the other to house.
? New: Engine temperature and oil pressure alarms.
? New: Oil pressure safety switch for electric fuel pump.
? New: Seawater coolant flow alarm (not fully installed yet).
? New: Vee berth starboard cabin light.
? New: Two galley lights.
? New: Main cabin light.
Other Gear
? New: Kuuma stainless steel rail-mounted BBQ and cover.
? New: Four lifejackets.
? Six-pad steel Marine Cradle Shop cradle. Pad carpets revised xxxx.
? Stainless steel transom swinging swim ladder.
? Boom sun shade canvas awning, excellent condition; added sunbrella wings in xxxx.
? Fortress anchor.
? Bruce anchor.
? Kedging anchor.
? Dan buoy.
? Older rope/chain rode.